# BCM94704agr board as l2 switch # Copyright 2007, Broadcom Corporation # All Rights Reserved. # # This is UNPUBLISHED PROPRIETARY SOURCE CODE of Broadcom Corporation; # the contents of this file may not be disclosed to third parties, copied # or duplicated in any form, in whole or in part, without the prior # written permission of Broadcom Corporation. # $Id: bcm94704agr-sw.txt,v 1.1.1.1 2008/07/21 09:20:53 james26_jang Exp $ boardtype=0x042f boardnum=${serno} # Board revision 1.0 boardrev=0x10 # BCM5325 RoboSwitch requires reverse MII initialization boardflags=0x10 # MIPS clock frequency in MHz clkfreq=264 # 64 MB DDR SDRAM (4 Meg x 16 x 2) sdram_init=0x0009 sdram_config=0x0062 sdram_refresh=0x0000 sdram_ncdl=0 # BCM5325 et0macaddr=00:90:4c:4e:${maclo} et0phyaddr=30 et0mdcport=0 # AC101L et1macaddr=00:90:4c:4f:${maclo} et1phyaddr=5 et1mdcport=1 # PMON variables dl_ram_addr=a0001000 os_ram_addr=80001000 os_flash_addr=bfc40000 lan_ipaddr=192.168.1.1 lan_netmask=255.255.255.0 scratch=a0180000 boot_wait=on # Watchdog timer in ms watchdog=3000 # Reset reset_gpio=7 # glue between bootloader and firmware landevs=et0 et1 wl0 wl1 wandevs=