# bcm94712agr board with sdram as l2 switch. # Copyright 2007, Broadcom Corporation # All Rights Reserved. # # THIS SOFTWARE IS OFFERED "AS IS", AND BROADCOM GRANTS NO WARRANTIES OF ANY # KIND, EXPRESS OR IMPLIED, BY STATUTE, COMMUNICATION OR OTHERWISE. BROADCOM # SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS # FOR A SPECIFIC PURPOSE OR NONINFRINGEMENT CONCERNING THIS SOFTWARE. # $Id: bcm94712agr-sd-sw.txt,v 1.1.1.1 2008/07/21 09:20:53 james26_jang Exp $ boardtype=0x0451 boardnum=${serno} # Board revision 3.3 boardrev=0x33 boardflags=0x0288 sromrev=2 # MIPS clock frequency in MHz clkfreq=200 # 16 MB SDR SDRAM (4 Meg x 16 x 2) sdram_init=0 sdram_config=0x0022 sdram_refresh=0x0000 sdram_ncdl=0 # Ethernet w/Admtek switch et0macaddr=00:90:4c:76:${maclo} et0phyaddr=30 et0mdcport=0 # ADMTek switch mgmt i/f GPIO mapping gpio5=adm_rc # No eth1 et1phyaddr=0x1f # Make the d11 i/f single band wl0id=0x4320 # 4712 802.11g parameters il0macaddr=00:90:4c:75:${maclo} aa0=3 ag0=2 pa0maxpwr=60 pa0itssit=62 pa0b0=0x1486 pa0b1=0xfaa8 pa0b2=0xfe47 # Wireless LED GPIO mapping/behavior wl0gpio2=0 # Commons wireless parameters cctl=0 ccode=0 # Bootlaoder variables dl_ram_addr=a0001000 os_ram_addr=80001000 os_flash_addr=bfc40000 lan_ipaddr=192.168.1.1 lan_netmask=255.255.255.0 scratch=a0180000 boot_wait=on reset_gpio=7 # Watchdog timer in ms watchdog=3000 # glue between bootloader and firmware landevs=et0 wl0 wl1 wandevs=