# BCM94712LGR SDR board as L2 switch # Copyright 2007, Broadcom Corporation # All Rights Reserved. # # THIS SOFTWARE IS OFFERED "AS IS", AND BROADCOM GRANTS NO WARRANTIES OF ANY # KIND, EXPRESS OR IMPLIED, BY STATUTE, COMMUNICATION OR OTHERWISE. BROADCOM # SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS # FOR A SPECIFIC PURPOSE OR NONINFRINGEMENT CONCERNING THIS SOFTWARE. # $Id: bcm94712lgr-sd-sw.txt,v 1.1.1.1 2008/07/21 09:20:53 james26_jang Exp $ boardtype=0x0460 boardnum=${serno} # Board revision 1.0 boardrev=0x10 boardflags=0x0618 sromrev=2 # MIPS clock frequency in MHz clkfreq=200 # 8 MB SDR SDRAM (4 Meg x 16) sdram_init=2 sdram_config=0x0022 sdram_refresh=0x0000 sdram_ncdl=0 # Ethernet w/BCM5325E switch et0macaddr=00:90:4c:88:${maclo} et0phyaddr=30 et0mdcport=0 # BCM5325E switch reset gpio6=robo_reset # Make the d11 i/f single band wl0id=0x4320 # 4712 802.11g parameters il0macaddr=00:90:4c:89:${maclo} aa0=3 ag0=2 pa0maxpwr=60 pa0itssit=62 pa0b0=0x1599 pa0b1=0xfad3 pa0b2=0xfed4 # Commons wireless parameters cctl=0 ccode=0 # Bootlaoder variables dl_ram_addr=a0001000 os_ram_addr=80001000 os_flash_addr=bfc40000 lan_ipaddr=192.168.1.1 lan_netmask=255.255.255.0 scratch=a0180000 boot_wait=on # Watchdog timer in ms watchdog=3000 # Bootloader and OS glue landevs=et0 wl0 wandevs=