# BCM94712LGR DDR board # Copyright 2007, Broadcom Corporation # All Rights Reserved. # # THIS SOFTWARE IS OFFERED "AS IS", AND BROADCOM GRANTS NO WARRANTIES OF ANY # KIND, EXPRESS OR IMPLIED, BY STATUTE, COMMUNICATION OR OTHERWISE. BROADCOM # SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS # FOR A SPECIFIC PURPOSE OR NONINFRINGEMENT CONCERNING THIS SOFTWARE. # $Id: bcm94712lgr.txt,v 1.1.1.1 2008/07/21 09:20:53 james26_jang Exp $ boardtype=0x0460 boardnum=${serno} # Board revision 1.7 boardrev=0x17 boardflags=0x0758 sromrev=2 # MIPS clock frequency in MHz clkfreq=200 # 32 MB DDR SDRAM (16 Meg x 16) sdram_init=0x000b sdram_config=0x0062 sdram_refresh=0x0000 sdram_ncdl=0 # Ethernet w/BCM5325E switch et0macaddr=00:90:4c:88:${maclo} et0phyaddr=30 et0mdcport=0 # BCM5325E switch reset gpio6=robo_reset # Make the d11 i/f single band wl0id=0x4320 # 4712 802.11g parameters il0macaddr=00:90:4c:89:${maclo} aa0=3 ag0=2 pa0maxpwr=76 pa0itssit=62 pa0b0=0x153d pa0b1=0xfb91 pa0b2=0xfeb7 opo=8 # Commons wireless parameters cctl=0 ccode=0 # Bootlaoder variables dl_ram_addr=a0001000 os_ram_addr=80001000 os_flash_addr=bfc40000 lan_ipaddr=192.168.1.1 lan_netmask=255.255.255.0 scratch=a0180000 boot_wait=on reset_gpio=7 # Watchdog timer in ms watchdog=3000 # Robo switch config (vlan0:LAN, vlan1:WAN) vlan0ports=1 2 3 4 5* vlan0hwname=et0 vlan1ports=0 5u vlan1hwname=et0 #Bootloader and OS glue landevs=vlan0 wl0 wandevs=et0