# BCM95351BU ddr board # Copyright 2007, Broadcom Corporation # All Rights Reserved. # # THIS SOFTWARE IS OFFERED "AS IS", AND BROADCOM GRANTS NO WARRANTIES OF ANY # KIND, EXPRESS OR IMPLIED, BY STATUTE, COMMUNICATION OR OTHERWISE. BROADCOM # SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS # FOR A SPECIFIC PURPOSE OR NONINFRINGEMENT CONCERNING THIS SOFTWARE. # $Id: bcm95351bu_ddr.txt,v 1.1.1.1 2008/07/21 09:20:53 james26_jang Exp $ boardtype=0x047a boardnum=${serno} # VLAN + ROBO boardflags=0x0110 # Board revision 1.2 boardrev=0x12 # MIPS clock frequency in MHz clkfreq=200 # 16 MB SDR SDRAM (4 Meg x 16 x 2) sdram_init=0x0009 sdram_config=0x62 sdram_refresh=0x0000 sdram_ncdl=0 # Bootloader variables dl_ram_addr=a0001000 os_ram_addr=80001000 os_flash_addr=bfc40000 lan_ipaddr=192.168.1.1 lan_netmask=255.255.255.0 scratch=a0180000 boot_wait=on reset_gpio=3 # Watchdog timer in ms watchdog=3000 # Ethernet w/Robo switch et0macaddr=00:90:4c:9c:${maclo} et0phyaddr=30 et0mdcport=0 # Robo switch config (vlan0:LAN, vlan1:WAN) vlan0ports=1 2 3 4 5* vlan0hwname=et0 vlan1ports=0 5u # Bootloader and OS glue landevs=vlan0 wl0 wl1 wandevs=et0 # SES parameters gpio2=ses_button # # --- on-chip d11 device --- # # 802.11g parameters sb/7/il0macaddr=00:90:4c:9d:${maclo} sb/7/aa0=1 sb/7/ag0=255 sb/7/pa0maxpwr=76 sb/7/pa0itssit=62 sb/7/pa0b0=0x15c8 sb/7/pa0b1=0xfa80 sb/7/pa0b2=0xfe65 sb/7/opo=12 # LED GPIO assignments sb/7/wl0gpio2=0 # misc. parameters sb/7/ccode=0 # # --- off-chip d11 device --- # pci/1/1/sromrev=2 # ALTIQ + HGPA + AB + CCK + AD pci/1/1/boardflags=0xa248 # LED GPIO assignments pci/1/1/wl0gpio0=2 pci/1/1/wl0gpio1=0 pci/1/1/wl0gpio2=4 # misc. parameters pci/1/1/ccode=0