#A4# #show current temperature# #select temperature preset# #change temperature preset# #change idle temperature# #enable / disable debug mode# #change PID controller kp# #change PID controller ki# #change PID controller kd# #UP/DOWN button (short press)# #SET button# #timeout or SET button# #SET button# #SET button# #SET button# #SET button# #SET button# #UP/DOWN button (hold)# #only if enabled at build# #always available# #CONF_PRESETS (default on)# #CONF_IDLE (default on)# #CONF_DEBUG (default off)# #CONF_KCONF (default off)# #CONF_KCONF (default off)# #CONF_KCONF (default off)# #build config option:# #Xytronic-lf Open Source firmware menu structure# #CONF_ADJ (default on)# #temperature controller adjustment (+/- 99 °C)# #SET button#